Setup Examples
Read Type Selection
1. In measurement mode, press
2. Press
lower line. Press
3. Press
CONT = Continuous
AUTO = AUTO-READ™
Note: In AUTO-READ mode, the meter will display the measurement as it stabilizes and lock and hold the
measurement when it is stable. AR and unit of measure will blink until the reading is stable. When the
reading is stable it is held on the screen and AR is lit.
Press
In Continuous read mode, the meter will continuously measure and update the display. The unit of
measure will flash. When the reading has been stable, "READY" will appear. This read type is useful
when performing an experiment that requires continuous measurements to be taken, regardless of the
measurement stability.
4. Press
Entering the Nominal Cell Constant for Conductivity
1. Press
2. Press
3. Press
Note: Holding the button down will make the value change faster.
4. Press
Adjusting the TDS Factor
The default value is 0.49.
1. In measurement mode, press
2. Press
3. Press
Note: Holding the button down will make the value change faster.
4. Press
Thermo Scientific Orion Star A112 Benchtop and Star A122 Conductivity Portable Meters
.
three times in setup until "4.0" is shown on the top line and "READ" is shown on the
.
or
to select the measurement mode:
to take a new measurement.
to save configuration and
to enter the setup mode.
three times to enter the 1.0 configuration menu and the submenu for cell constant.
or
to enter the cell constant value to use for automatic calibration.
to save configuration and
.
two times ("TDSF" is displayed on the top line).
or
to enter the TDS factor.
to save configuration and
to return measurement mode.
to return measurement mode.
to return measurement mode.
9