Connecting The Power Supply; Poe+ (Power Over Ethernet+) - Canon ME20F-SHN Setup Manual

Connecting the Power Supply

Connecting the Power Supply
Power can be supplied to the camera in the two ways described below. Please be sure to read the user manual
for the dedicated power supply before use.
IMPORTANT
• EF Cinema lenses are not available when using PoE+ power supply. Use an external power supply (DC
12
power supply) for the camera with an EF Cinema lense attached.

PoE+ (Power over Ethernet+)

The camera supports PoE+ functions. Power can be supplied to the camera by using a LAN cable connected
to a PoE+ HUB that conforms to the IEEE802.3at Type2 standard.
IMPORTANT
• Check with your dealer for more information about PoE+ HUB and Midspan technology.
Midspan (a LAN cable power supply device) is a device that, like a PoE+ HUB, supplies power to the camera
via a LAN cable.
• Some PoE+ HUBs allow the limitation of power for each port, but applying limits may interfere with
performance. If using this type of PoE+ HUB, do not limit the operating power.
• Some PoE+ HUBs have limits for the total power consumption for the ports, which can interfere with
performance when multiple ports are in use. For more information, check the instruction guide for your
PoE+ HUB.
• When the camera is connected to both a PoE+ HUB and an external power supply (11 V DC – 17 V DC),
power from the external power supply is given priority. The power supplied to the camera stops if the
external power supply is removed while both power supplies are connected. In this case, the power will be
supplied again by disconnecting and reconnecting the LAN cable.