Connect the Camera to the Network and Perform the Initial Setting
Connect the Camera to the Network and Turn the Power Supply On
First, connect the camera to the network. Connect the camera and PC via the HUB with a LAN
cable, connect the camera to the network, then turn the power on. If 20 minutes have passed since
the VB-C300 was turned on, it can no longer be detected by the VB Initial Setup Tool (➝ P.2-7). In
this case, turn the camera OFF then ON again.
The VB-C300 is equipped with the PoE (Power over Ethernet) function. The power can be supplied
to the camera via the LAN cable from an IEEE 802.3af-compliant PoE HUB.
When using PoE HUB
(Rear)
When using the AC adapter (optional) or external power supply, connect them as shown below.
When using the AC Adapter (Optional) or external power supply
AC power cable
2-4
OUT IN-2 IN-1
DC IN 12-13V
LINE
LINE
IN
OUT
AC IN 24V
100/10BT
VIDEO
B A
OUT
LAN cable
OUT IN-2 IN-1
DC IN 12-13V
LINE
LINE
IN
OUT
AC IN 24V
B A
100/10BT
VIDEO
OUT
LAN cable
AC Adapter
AC power cable
Notebook PC
PoE HUB
(Rear)
HUB
The figure shows the AC adapter (optional).
Notebook PC