14-3.Indoor Unit (Setting By Wireless Remote Controller) - Fujitsu AUYG07LVLA Design & Technical Manual

14-3. Indoor unit (setting by wireless remote controller)
• The function settings of the control of the indoor unit can be changed by this procedure accord-
ing to the installation conditions. Incorrect settings can cause the indoor unit malfunction.
• After the power is turned on, perform the "Function setting" according to the installation condi-
tions using the remote controller.
• The settings may be selected between the following two: Function number or Setting number.
• Settings will not be changed if invalid numbers or setting numbers are selected.
¢ Preparation
Before connecting the power supply of the indoor unit, reconfirm following items:
• Piping air tight test and vacuuming have been performed firmly.
• There is no wiring mistake. Then, connect the power supply of the indoor unit.
¢ AR-RAH2E/AR-RAH1E
 Button name and function
During address setting mode, indoor unit reject the any operation command from remote con-
troller.
MODE button
- Starts the function setting mode
- Changes the display digits
START/STOP button
Transmits function setting
TIMER MODE button
Transmits function mode
NOTE: Actual number of buttons might be different from the figures in following instructions.
Outdoor unit
Breaker on
Function number
Refer to Function details.
Setting number
Refer to Function details.
FAN button
Switches between the setting number (bottom line)
and function number (top line)
SET TEMP. "
Increases and decreases the displayed number
- 202 -
Indoor units
" and " " button