13-3.Changing The Current Limit Function - Fujitsu AUYG07LVLA Design & Technical Manual

¢ Description of display
LED display lamp
(1) POWER/MODE
(2) ERROR
(3) MONITOR
Switch
• For the test run start and stop.
SW1 Push
• For the pump down start and stop.
• For when check run function is activated.
SW2 Push • For displaying the check run.
• For resetting the Automatic wiring correction memory.
SET1-1 DIP For selecting cooling or heating during test operation.
SET1-2 DIP For switching SW1 operation.
SET1-3 DIP (Prohibited)
SET1-4 DIP (Prohibited)
• For selecting outdoor unit low noise operation function.
SET2-1 DIP
• To use this function, the Central remote controller
(option) is necessary.
SET2-2 DIP (Prohibited)
SET2-3 DIP
Changing the current limit
SET2-4 DIP
SET3-1 DIP (Prohibited)
SET3-2 DIP (Prohibited)
SET3-3 DIP (Prohibited)
SET3-4 DIP (Prohibited)
Be sure to disconnect the power supply or turn off the breaker before changing the DIP switch
setting.
• Turns on when the power supply is ON (Including
when error occurs).
Green
• Indicate the MODE by the number of flashes when
the installation function is active.
Red Flashes at high-speed when there is an error.
A Red
• Displays the location and contents of errors when
B Red
there is an error. (Refer to Chapter 14-3.
C Red
code"
D Red
• Displays when check run is activated. (Refer to
E Red
Chapter 14-1.
F Red
Function or operation method
- 327 -
Function or operation method
on page 336 for details.)
"Check run" on page 329 for details.)
Factory setting
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
OFF (Do not change)
"Error
—
—
OFF
OFF
OFF
OFF