Fujitsu AUYG07LVLA Design & Technical Manual page 212

7. Proceed to number setting by pressing the FAN button.
To return to the function number selection, press the FAN button again.
8. Select the setting number by pressing the
Each time the MODE button is pressed, it switches between the left digit and the right digit.
9. Send the function mode information by pressing the TIMER MODE button once.
10. Send the function setting information by pressing the START/STOP button once.
2 short beeps will be emitted from the indoor unit when the signal is received correctly. If
wrong code is set, no beep sound will be emitted.
NOTE: Press START/STOP button within 30 seconds after pressing TIMER MODE button.
Function details: Refer to Chapter 14-6.
or the button.
Change digit
2 short beeps
2 short beeps
"Function details" on page 241.
- 204 -