Displaying Working Parameters; Weight Stack Motor Running Time; Weight Stack Motor Test Cycles; Number Of Relay Switching Cycles To Move The Weight Stack Motor Downward - Technogym BIOSTRENGTH LINE Service Maintenance Manual

9.5. DISPLAYING WORKING PARAMETERS

In order to check the status of the machine and perform regular maintenance, it is possible to display
the working parameter values using a special procedure. This procedure may be activated, when the
machine is in stand-by, by pressing keys "1", "3" and "4" simultaneously. To access this procedure,
you must enter the password that protects against unauthorized access:
After entering the password "1508" and pressing "Enter" to continue, the machine begins to offer
the saved parameter values in sequence. Press the "Enter" key to move on to the next parameter, or
the "Clear" key to quit the procedure. The following information will be displayed on the LED
matrix at this point:
9.5.1. W
EIGHT STACK MOTOR RUNNING TIME
This is the total number of hours for which the weight stack motor has been used.
Press ENTER to continue.
9.5.2. W
EIGHT STACK MOTOR TEST CYCLES
The number of cycles performed by the weight stack motor during the test procedure described in
paragraph 6.2. "Automatic components test".
Press ENTER to continue.
9.5.3. N
UMBER OF RELAY SWITCHING CYCLES TO MOVE THE WEIGHT STACK
MOTOR UPWARD
The number of times the weight stack motor interface board relays have switched in order to move
the motor upward.
Press ENTER to continue.
9.5.4. N
UMBER OF RELAY SWITCHING CYCLES TO MOVE THE WEIGHT STACK
MOTOR DOWNWARD
The number of times the weight stack motor interface board relays have switched in order to move
the motor downward.
Page 9.18
BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
P A S S W O R D =
*
M O T O R W E I G H T
H O U R S
M O T O R W E I G H T
C Y C L E S :
W E I G H T R E L A Y
C Y C L E S :
O N
X X : X X
X X X X X
U P
X X X X X