Installation Instructions; Specifications And Requirements; Installation; First Power - Technogym BIOSTRENGTH LINE Service Maintenance Manual

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1

5. INSTALLATION INSTRUCTIONS

5.1. SPECIFICATIONS AND REQUIREMENTS

For proper installation of the equipment, make sure that:
1. The equipment is installed on a level, vibration-free surface with a sufficient capacity to support
its weight plus that of the user.
2. The area is not dusty or sandy.
3. The operating temperature and humidity requirements indicated in paragraph 2.3. are observed.
4. The equipment is not placed near sources of heat, sources of electromagnetic disturbance
(television sets, electric motors, antennas, high-voltage power lines, appliances, etc....) or
medical equipment.
5. The mains voltage is the same as indicated on the equipment's rating plate.
6. The electrical system is properly grounded.
7. The electrical socket is used solely by the equipment, and supplies enough power to run the
machine. See paragraph 2.1.1. for power consumption rates of individual machines.
8. The machine makes the connection available to other machines in cascade. The recommended
maximum number of machines to be connected in cascade is limited by the maximum capacity
of 10 A of the power socket of the machine connected to the power supply mains. In this case,
make sure that the power socket supplies at least 10 A.
9. The equipment power cord is placed in such a way that people will not trip over it. We
recommend that you use the raceways supplied with the equipment for this purpose.

5.2. INSTALLATION

For proper installation of the equipment, follow the machine assembly procedure described in the
"Biostrength line – installation manual" provided with each machine. Once the machine is installed
in the proper position:
1. Connect the power supply cable to the equipment.
2. Set the start button to 0.
3. Connect the power supply cable to the power socket.
5.3. FIRST POWER-ON
Once installation is complete, the machine is ready to be turned on. To power-on the machine,
simply switch the start button from position 0 to position 1.
When switched on, the machine performs a start-up procedure that:
• sounds the buzzer;
• turns on all LEDs;
Page 5.1