Table Of Configuration Parameters - Technogym CROSS PERSONAL Service Maintenance Manual

9.2.1.1.

Table of configuration parameters

To correctly display the parameter values, you need to load them from the low kit,
using the "Read from low kit" function.
After any changes to the parameter values, you need to save them in the low kit using
the "Write to low kit" function
Id
Units
(Par.)
1 decimal [Rt]
2 [Rvel]
3 mA [Im]
4 W [Pmc]
5 cents [Km]
in
6 0.1N [Ca]
7 °C [Tea]
[RPMmin
8 User rpm
]
9 Type/sec [RpmF1]
10 User rpm [RpmF2]
11 [Rvel]
12 0.1N [D_Ca]
13 - -
Page 9.4
Name
Transmission Ratio
Speed ratio
Minimum braking
Constant maximum power
Power factor correction (constant torque)
User friction torque
Maximum temperature on the coil
Minimum user SPM (start cut braking ramp)
Flywheel target RPM speed in standby
(and power-on speed for self powered)
Rpm filter threshold
Speed ratio (decimal part)
User delta friction torque
Enable flag for registers at address ≥ 100
CROSS PERSONAL: Service & maintenance manual - rev. 1.1
Description Value
134
1
0
200
100
75
125
35
1
75
60
2
1