Beckman Coulter COULTER EPICS XL Service Manual page 706

BAR-CODE SPECIFICATIONS
HAND-HELD BAR-CODE SCANNER OPTION
General Parameters
Table F.3-2 Hand-Held Bar-Code Scanner - General Parameters
Item
AUTOSENSE OPERATION
WEDGE MODE
BEEPER OPERATION
INTERCHARACTER DELAY
PREFIX
SUFFIX
TERMINAL ID
CODE IDENTIFIER
PREAMBLE
POSTAMBLE
POWER CONSUMPTION
LASER REDUNDANCY
SET LASER TIMEOUT
* Scan this code from the OEM User's Manual.
Serial Communication Parameters
Not applicable.
Symbologies
IMPORTANT
FNC4, and FS (hexadecimal 1C) characters in the bar-code information, incorrect identification of sample
tubes can occur. To prevent incorrect identification of sample tubes, do not use FNC1, FNC4, and FS
(hexadecimal 1C) characters in your bar-code information.
Table F.3-3 Hand-Held Bar-Code Scanner - Symbologies
Item
UPC (A & E)
EAN/JAN
CODE 39
CODE 39 CHECK CHARACTER
CODE 39 MINIMUM LENGTH
CODE 39 MAXIMUM LENGTH
CODE 39 START/STOP CHAR.
CODE 39 CHECK CHARACTER
* Scan this code from the OEM User's Manual.
F.3-2
Code*
NN
CE
AD
GA
IA
MC
JA
FA
KA
LA
@A
BE
BH
Possible incorrect identification of sample tubes. If sample tube bar-code labels use FNC1,
Code*
QA
RA
0B
0E
0H
0I
0F
0K
Function
Disabled
Enabled
Beeper ON; volume LOUD
No intercharacter delay
None
Suffix CR
Disabled
Disabled
None
None
Enable full power
Enable four times laser redundancy
Set scan beam timeout to six seconds
Function
Disable UPC (both A & E)
Disable EAN/JAN
Enable standard CODE 39
Enable MODULO 43 check character
Minimum length = 01
Maximum length = 06
Do not XMIT START/STOP character
Disable transmit of check character
PN 4237029F