Optional Log Set Installation - Regency Fireplace Products Horizon HZO42-NG Owners & Installation Manual

installation
|
26

OPTIONAL LOG SET INSTALLATION

Read the instructions below carefully and refer to the images. If
the logs are broken do not use the unit until they are replaced.
Broken logs can interfere with pilot operation.
Install 3lbs of glass crystal on the burner (follow glass crystal
instruction sheet) before installing logs.
Improper positioning of the logs may create carbon build-up
and can alter the unit's performance which is not covered
under warranty.
Log kit # 326-930 contains the following pieces:
Part # Description
A x 1 Log
B x 1 Log
C x 1 Log
D x 1 Log
E x 1 Log
1) Install logs A and C on the burner as shown below. Orient the logs in the same way and in a similar location on the left side of the burner as
depicted in Diagram 2.
A
C
2) Install log B on the burner as shown below. Orient log B across log A in the same way and in a similar position as depicted in Diagram 3.
A
3) Install log E on the right side of the burner as shown below. Orient log E in the same way and in a similar position as depicted in Diagram 4.
26 |
Regency Horizon® HZO42 Gas Fireplace
918-899
LOG SET INSTALLATION
Installation of Refl ective Panels must be completed before installing the log set.
Installation of Reflective Panels must be completed before installing the log set.
B
A
B
C
Diagram 2
Diagram 3
Diagram 4
1
OUTDOOR 42
D
E
F
Diagram 1
E
02/15/11