Regency Fireplace Products Horizon HZO42-NG Owners & Installation Manual page 40

maintenance
|
40
DIGITAL FIREPLACE BURNER CONTROL REMOVAL
1
Remove 6 screws in locations shown below to access DFC.
6th screw located at back
2. Remove the DFC from the floor of the firebox by removing 2 screws in
locations shown below to release DFC bracket.
4. Disconnect the Black Pilot sensor wire with Red Spade connector from
the 'ON' on DFBC (Digital fireplace burner control) box.
See Diagram 1 below.
Pilot Sensor
Wire
40 |
Regency Horizon® HZO42 Gas Fireplace
Diagram 1
5. Disconnect the Black sparker wire with black spade connector from CN3.
See Diagram 2 below.
Sparker Wire
6. Disconnect the white and green On/Off switch wires.
See Diagram 3 below.
Green
7. Disconnect the yellow ground wire with green diagonal stripe for pilot
(CN2). See Diagram 4 below.
Ground wire
8. Disconnect the three valve wires (yellow wire with green stripe).
See Diagram 5 below.
Valve wire
Diagram 2
Diagram 3
ON/OFF wires
Diagram 4
Diagram 5
White