Redundant Hot-Plug Power Supply Enablement Kit Option - HP ProLiant ML350e Gen8 User Manual

Connect each power cord to the server.
23.
Connect each power cord to the power source.
24.
Power up the server (on page 22).
25.
Redundant hot-plug power supply enablement kit
option
To install the component:
Power down the server (on page 22).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the front bezel (on page 23).
3.
Place the server on its side.
4.
Remove the access panel (on page 24).
5.
If installed, remove the PCI air baffle (on page 26).
6.
Remove the system air baffle (on page 27).
7.
If a Smart Array controller is installed, disconnect the capacitor pack cable from it, and then remove
8.
the capacitor pack holder from the server.
Remove any installed full-length PCI expansion boards
9.
on page 28).
Remove the fan modules and the fan blank (on page 29).
10.
Disconnect the power cables from the system board, drive cages, and optical drive.
11.
("Remove the full-length expansion
Hardware options installation 70
board"