Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Unlock the front bezel (on page 23).
3.
Place the server on its side.
4.
Remove the access panel (on page 24).
5.
If installed, remove the PCI air baffle (on page 26).
6.
Remove any full-length PCI expansion boards installed in PCI slots 3, 4, 5 and 6
7.
full-length expansion
Install the FBWC module in the cache module connector on the system board
8.
components" on page 10).
Install the FBWC capacitor pack.
9.
CAUTION: When connecting or disconnecting the cache module cable, the connectors on
the cache module and cable are susceptible to damage. Avoid excessive force and use
caution to avoid damage to these connectors.
board" on page 28).
("Remove the
("System board
Hardware options installation 59