Install the screws into the diskette drive, as shown.
6.
Slide the diskette drive into the diskette drive bay.
7.
Connect the data and power cables to the rear of the device.
8.
Connect the diskette drive cable to the diskette drive cable connector on the system board
9.
board
components" on page 11).
Install the access panel (on page 20).
10.
Do one of the following:
11.
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
o
Power up the server (on page 17).
12.
Redundant hot-plug power supply option
("System
Hardware options installation 46