HP ProLiant ML350e Gen8 User Manual page 65

Route the opposite ends of the Mini-SAS cables through the cable management clip, and then
c.
connect the cables to the storage controllers.
Install hot-plug drives.
15.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
Populate drive bays based on the drive numbering sequence. Start from the drive bay with the
lowest device number. For device numbering information see "SAS and SATA device numbers (on
page 14)."
Install the fan modules and the fan blank (on page 30).
16.
Install any full-length PCI expansion boards that were removed
17.
page 61).
Install the system air baffle (on page 27).
18.
If removed, install the PCI air baffle
19.
Install the access panel (on page 25).
20.
Return the server to an upright position.
21.
Install the front bezel (on page 24).
22.
("PCI air baffle option" on page 37).
("Installing an expansion
Hardware options installation 65
board" on