Step 2: Place the wall-mount plate on the rear panel of the Industrial
Media Converter.
Step 3: Use the screws to screw the wall-mount plate on the
Industrial Media Converter.
Step 4: Use the hook holes at the corners of the wall-mount plate to
hang the Industrial Media Converter on the wall.
Step 5: To remove the wall-mount plate, reverse the steps above.
3.3 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of
Media Converter
is used for two DC redundant power
follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into Contacts 1 and 2 for
power 1 or 5 and 6 for power 2.
V1+ V1-
1 2 3 4 5 6
V1+
V1-
1A@24V
V2+ V2-
DC1
Fault
DC2
inputs.
V2+ V2-
Input
DC12~48V, AC 24V
Industrial
Please
15