Troubleshooting - Planet IXT-705AT User Manual

4. Troubleshooting

This chapter contains information to help you solve issues. If the
Industrial Media Converter is not functioning properly, make sure the
Industrial Media Converter is set up according to instructions in this
manual.
The per port LED is not lit
Solution:
Check the cable connection of the Industrial Media Converter.
Performance is bad
Solution:
Check the speed duplex mode of the partner device. The Industrial
Media Converter is run at auto-negotiation mode and if the partner is
set to half duplex, then the performance will be poor.
Per port LED is lit, but the traffic is irregular
Solution:
Check that the attached device is not set to dedicate full duplex. Some
devices use a physical or software switch to change duplex modes.
Auto-negotiation may not recognize this type of full-duplex setting.
Why the Industrial Media Converter doesn't connect to the
network
Solution:
Check per port LED on the Industrial Media Converter. Make sure the
cable is installed properly. Make sure the cable is the right type. Turn
off the power. After a while, turn on the power again.
Can I install MTB-SR or the other SFP+ module with non wide
temperature feature into the SFP+ slot of Industrial Media
Converter?
Solution:
Yes, you can. However, the MTB-SR and the other SFP+ module with
non wide temperature feature cannot operate under -40 to 75 degrees
C.
20