Error Terms - Keysight Technologies N5224A Service Manual

General Purpose Maintenance Procedures

Error Terms

Error Terms
Using Error Terms as a Diagnostic Tool
By examining error terms, you can monitor system performance for preventive
maintenance and troubleshooting purposes.
The the most common causes of error term anomalies are:
— calibration kit devices
— cables
— adapters and accessories
— the assemblies from the signal separation group of the analyzer
These items also affect the magnitude and shape of the error terms. For
highest measurement accuracy, make sure of the following:
•
•
Preventive Maintenance
If you print or plot the error terms at set intervals (weekly, monthly and so
forth), you can compare current error terms to these records. A stable system
should generate repeatable error terms over long intervals, (for example, six
months). Look for the following:
— A long-term trend often reflects drift, connector and cable wear, or gradual
— A sudden shift in error terms may indicate the need for troubleshooting.
Troubleshooting
You can use the error terms as a tool to isolate faulty assemblies in the signal
separation group of your analyzer. You can compare the current values to
preventive maintenance records or to the typical values listed in
page
8-2
Use proper connector care. Connectors must be clean, gaged, and within
specification.
Use proper connection technique during measurement and calibration. For
information on connection technique and on cleaning and gaging
connectors, refer to "Review the Principles of Connector Care" on page 3-5
or to the calibration kit's user's and service guide.
degradation, indicating the need for further investigation and preventive
maintenance. Yet, the system may still conform to specifications. The cure is
often as simple as cleaning and gaging connectors and cables.
8-8.
Keysight N5224A/25A Service Guide
Table 8-1 on