Printing From A Direct Printer; Mptiii (Thermal Printer); Installing The Sanibel Mpt-Iii Thermal Printer; Modify The Custom Logo Printout - Interacoustics AA222 Additional Information

AA222 Additional Information
Enter Common Settings via Setup/Tests
15.
16. When the question "Do you want to install?" appears,
select Yes
17. After the installation is complete, select Back to access
the testing screen.
7.1.4

Printing from a direct printer

It is possible to print the results of the different audiometry and impedance measurements on the direct printer.
Below are some examples of the audiometry and impedance elements. If the name of the client has been
entered on the device the patient information will appear on printout.

7.2 MPTIII (thermal printer)

7.2.1

Installing the Sanibel MPT-III thermal printer

1. Ensure that the printer is powered by either battery or the power charger and that the paper is correctly
placed in the printer. For a detailed description of how to operate the MPT-III thermal printer, please
refer to the MPT-III Sanibel Mobile thermal mini printer user manual.
2. To set up the printer for MPT-III, press Setup – Instrument settings – Printer type – MPT-III.
3. Connect the MPT-III printer to the AA222 via the USB.
4. Turn on the printer.
5. The printer is now setup for printing. Press Print on the AA222 to obtain a printout of the audiometry
and impedance data.
7.2.2

Modify the custom logo printout

1. It is possible to change the print logo through Diagnostic suite. Connect the device to the PC and enter
Diagnostic suite.
2. Ensure that the device is switched on and properly connected.
3. Go to AUD – Menu – Setup – General Setup.
4. From the instrument settings press Upload Print Logo.
5. Find the picture that you would like to add and press Open. The logo will now be transferred, and ready
for use on your print.
Page 49