Table of Contents
Advertisement
9.0
Adjusting the multi-scanner
9.1
Adjusting and calibrating the instrument
You are advised to return the instrument to AMETEK Denmark A/S or
an accredited laboratory at least once a year for calibration and
adjustment.
•
Alternatively, you can calibrate/adjust the instrument yourself
using the AMETRIM Adjust and Calibration Software.
9.2
Introduction to AMETRIM Software
This software is supplied on the JOFRACAL CD-ROM. It can be run
directly from this CD-ROM and requires no special installation.
It is possible to make a disk containing the AMETRIM software. From
this disk AMETRIM can be installed on the hard disk of the computer,
but the disk has to be in the disk drive when running the software.
To use the software, you need:
PC hardware requirements
•
IBM compatible PC with 486 or higher processor (Pentium
MHz recommended).
•
32 MB of RAM (64 MB recommended).
•
40 MB available hard-disk space.
•
Standard VGA monitor (800 x 600, 256 colours), (1024 x 768
recommended).
•
CD-ROM drive.
•
One vacant RS 232 Serial Port.
PC software requirements
•
Microsoft Windows
®
Windows
XP.
•
System font: MS Sans Serif and Arial.
125614 04
®
98, Microsoft Windows
2000, Microsoft Windows
®
ME, Microsoft Windows
2017-08-11
®
NT 4.0, Microsoft
TM
200
®
39
Advertisement
Table of Contents
