Table of Contents
Advertisement
4.0
Setting up the multi-scanner
Warning
•
The multi-scanner must not be used for any purposes
other than those described in this manual, as it might
cause a hazard.
•
Do not connect the multi-scanner to input voltages
above 30 Volts.
•
Only use the specified mains adaptor approved for the
voltage and plug configuration in your area.
•
Do not operate the multi-scanner in environments of
explosive gas, vapour, or dust.
•
The multi-scanner has been designed for indoor use
only and is not to be used in wet locations.
•
The multi-scanner is not designed for operation in
altitudes above 2000 meters.
•
Do not apply more than the rated voltage/current. See
specifications for supported ranges.
•
Select the proper function and range for your
measurement.
Caution...
In case of resistive measurements, it is very important that
no capacities are present in the circuit loop. If present, they
must be discharged, before wires are connected to the
instrument.
When commencing the switch test, which is in fact a
resistive measurement, the thermostats must not be
connected to any other voltage source.
125614 04
2017-08-11
15
Advertisement
Table of Contents
