Loading Material; Loading Media From Roll; Positioning The Media Roll On The Roll Retainer - CAB SQUIX Operator's Manual

4

Loading Material

i
Notice!
For adjustments and simple installation work, use the accompanying Allen key located in the top section of
the print unit. No other tools are required for the work described here.
4.1

Loading Media from Roll

4.1.1

Positioning the Media Roll on the Roll Retainer

10
9
8
7
6
Figure 11 Loading media from roll
1. Open cover (10).
2. Turn ring (2) at the margin stop (1) counterclockwise, so that the arrow points to the symbol
the margin stop.
3. Remove the margin stop (1) from the roll retainer (4).
4. Load label roll (3) on the roll retainer in such a way that the labels can be inserted into the printhead in the right
position. The printing side of the labels must be visible from above.
 SQUIX 4/4P
Re-mount the margin stop (1) onto the roll retainer (4). Push the margin stop (1) to the roll until the roll touches
the chassis and the roll retainer and a clear resistance is encountered.
 SQUIX 4M/4MP/4MT
Re-mount the margin stop (1) onto the roll retainer (4). Push the margin stop (1) to the roll until the roll touches
both roll retainers and a clear resistance is encountered.
5. Turn ring (2) clockwise, so that the arrow (10) points to the symbol
retainer (4).
6. Supply longer label strips:
For Peel-Off or Rewind mode: approx. 60 cm
For Tear-Off mode: approx. 40 cm
1
2
3
4
5
, and thus release
, and thus fix the margin stop (1) on the roll
13