Gazer CC100 User Manual page 10

To connect a Gazer car camera or install a video parking system
ENG
with Gazer car monitor or Gazer rear-view mirror with a built-in
monitor, use Gazer AC100 switching and control unit supplied
with the Gazer car camera.
Connect the black wire (GND) to the car ground line and the red
wire (ACC +) to the car's ACC supply line (ACC power goes ON
and OFF automatically when the car engine is ON or OFF).
Connect the camera's RCA video output to the monitor's RCA
video input, and the switching unit power connector (DC
CONNECTOR) to the monitor's power connector.
Connect the purple wire (REVERSE) to the reverse lights power
wire +12V. Connect the camera connector to the corresponding
switching unit connector.
Once connected this way, the switching and control unit will
simultaneously supply power to the camera and the monitor
whenever the car is put in the reverse gear (backup lamps light
up). In this case, this image from the rear view camera is
displayed on the monitor screen automatically.
Note.
installation, please contact your dealer or service station.
To avoid warranty loss, if your car is still under warranty,
please contact the warranty service station.
10
Connection scheme
For correct Gazer video parking system