YASKAWA SI-EN3/V Installation Manual page 31

No.
(Addr.
Hex)
F7-33 to
Dynamic Input Assembly
F7-42
Parameters
(405 to 40E)
<1> To start and stop the drive with the EtherNet/IP master device using serial communications, set b1-02 to 3 or set
the "Net Control" bit in the assemblies or Control Supervisor Object. To control the drive frequency reference of
the drive via the master device, set b1-01 to 3 or set the Net Reference bit in the assemblies or AC/DC Object.
<2> If F6-01 is set to 3, the drive will continue to operate when a fault is detected. Take safety measures, such as
installing an emergency stop switch.
<3> Cycle power for setting changes to take effect.
<4> If F7-13 is set to 0, then all IP Addresses (F7-01 to F7-04) must be unique.
<5> Set F7-01 to F7-12 when F7-13 is set to 0.
<6> Default setting differs by drive software version.
1012 to 1015: 0
 1016: 1
<7> Set F7-15 when F7-14 is set to 0 or 2.
<8> The setting values differ by drive software version.
1012 to 1015
Default: 0
Range: 0, 10, 100
 1016
Default: 10
Range: 10, 100
No.
U6-80 to U6-83 Online IP Address
U6-84 to U6-87 Online Subnet
U6-88 to U6-91 Online Gateway
U6-92 Online Speed
U6-93 Online Duplex
U6-98 First Fault
U6-99 Current Fault
YASKAWA ELECTRIC TOBP C730600 60A V1000 Option EtherNet/IP Installation Manual
Name
Parameters used in Input Assembly 166. Each
parameter contains a MEMOBUS/Modbus
address. The value sent for Input Assembly 166
will be read from this corresponding MEMOBUS/
Modbus address. A MEMOBUS/Modbus address
value of 0 means that the value sent for Input
Assembly 166 is not defined by the user, therefore
the option default register value will be returned.
Refer to Input Assemblies (Drive Produces) on
page 35
Modbus registers.
Table 9 Option Monitors
Name
IP Address currently available; U6-80 is the most
significant octet
Subnet currently available; U6-84 is the most
significant octet
Gateway currently available; U6-88 is the most
significant octet
Link Speed
Duplex Setting
First Option Fault
Current Option Fault
6 Related Drive Parameters
Description
for definitions of the default MEMOBUS/
Description
Values
Default: 0
Value Range
0 to 255
0 to 255
0 to 255
10: 10 Mbps
100: 100 Mbps
0: Half, 1: Full
–
–
EN 31