YASKAWA SI-EN3/V Installation Manual page 24

5 Installation Procedure
11.
Remove the option cover and pass the ground wire through the inside of the drive
bottom cover and into the through-hole for the ground wire at the front of the option.
Figure 15
V1000
12.
Attach the option to the drive. Properly seat the tabs on the left and right sides of the
option to the drive case.
Figure 16
13.
Connect the ground wire at the option ground terminal. Tighten the screw to 0.5 to
0.6 Nm or (4.4 to 5.3 in lbs) using an M3 Phillips screwdriver.
EN 24
Option Cover
Figure 15 Ground Wire Routing
V1000
Line up tabs
Line up tabs
Figure 16 Connect the Option
YASKAWA ELECTRIC TOBP C730600 60A V1000 Option EtherNet/IP Installation Manual