Storage - Elcometer CG60DL Operating Instructions Manual

10.1.3 Transferring all batches
1. Connect the gauge to a computer and start the data transfer software.
2. Press ON/OFF key to switch on the gauge.
3. Press MEM key to activate the data logging functions and settings.
4. Press UP / DOWN arrow keys to scroll to SEnd ALL flashing on the display.
5. Press the SEND key to send readings to the computer.
The display will show buSY during data transfer.
Wait until all the data has been transferred.
6. Press the MEM key to exit the data logging functions.

11 STORAGE

The Model CG60/CG60DL gauge has a Liquid Crystal Display. If the display is heated above
50°C (120°F) it may be damaged. This can happen if the gauge is left in a car parked in strong
sunlight.
Always store the gauge in its case when it is not being used.
If the gauge is to remain unused for long periods of time, remove the batteries and store them separately.
This will prevent damage to the gauge in the event of malfunction of the batteries.
33