Elcometer CG60DL Operating Instructions Manual page 13

Display segment
INMM/ s µ
INMM/ s
µ
INMM/ s
µ
Information displayed
The numeric portion of the display consists of 4 complete digits preceded by a leading '1',
and is used to display numeric values, as well as occasional simple words which indicate the
status of various settings. When the gauge is displaying thickness measurements, the
display will hold the last value measured, until a new measurement is made. Additionally,
when the battery voltage is low, the entire display will begin to flash. When this occurs, the
batteries should be replaced.
These eight vertical bars form the Stability Indicator. Only the left-most bar and the underline
will be on when the gauge is idle. Six or seven of the bars should be on when the gauge is
taking a measurement. If fewer than five bars are on, the gauge is having difficulty achieving
a stable measurement, and the thickness value displayed could be in error.
Refer to "Read display" on page 22 and "Transducers" on page 38 for information on how to
achieve a stable measurement.
When the + symbol is on and blinking, this indicates that the Model CG60DL is currently
operating in echo-echo (through-paint/coating) mode.
11