Elcometer CG60DL Operating Instructions Manual page 34

10.1.1 Transferring data
Model CG60
After taking a measurement, press the SEND key to send the measurement to the computer.
Model CG60DL
Follow the instructions in "Measurement options" on page 23
10.1.2 Transferring one batch
1. Connect the gauge to a computer and start the data transfer software - see "Transferring readings to a
computer" on page 31.
2. Press ON/OFF key to switch on the gauge.
3. Press MEM key to activate the data logging functions and settings.
4. Press SEND key to enter batch setup.
5. Press UP / DOWN arrow keys to scroll to the batch that is to be sent to the computer.
6. Press SEND key once again to select the batch. The display will flash FILE F-05 (or the batch
selected).
7. Press UP / DOWN arrow keys to scroll to LISt F-05 (or the batch selected) flashing on the display.
8. Press the SEND key to send readings to the computer. The display will show buSY during data
transfer. Wait until all the data has been transferred.
9. Press the MEM key to exit the data logging functions.
32