Table of Contents
Advertisement
Front Panel Features
Figure 4.
A
B
C
D
Reset Modes
Press the front panel
restart the Dante module in the AXI and leave all other settings unaffected (see
and Response Table for SIS Commands
attenuation and preset data).
To cause an absolute system reset of the Dante module back to factory default conditions,
press and hold the front panel reset button for 10 seconds until the AT (PoE) port LEDs
flash. Following this reset, the Dante module will proceed to its normal boot sequence. This
reset will:
•
•
•
AXI 02 AT
R
CONFIG
D
A
C
B
AXI 02 AT Front Panel Controls
Power LED Indicator — This green LED blinks during boot up and lights steadily
when the AXI 02 AT is fully operational. This LED also blinks amber for 10 seconds
when the device receives a Dante identification signal (see
Dante Device
on page 22).
USB Config Port — Connect a computer to this USB Mini-B port for device
configuration and firmware updates.
AT (PoE) Port — This RJ-45 port is used to connect the AXI 02 AT to a Dante network.
The AT (PoE) port supports digital audio transport (AT), communication with the Dante
network, communication with DSP Configurator for device configuration, and power
over Ethernet (PoE).
ATTENTION:
•
Power over Ethernet (PoE) is intended for indoor use only. It is to be connected
only to networks or circuits that are not routed to the outside plant or building.
•
L'alimentation via Ethernet (PoE) est destinée à une utilisation en intérieur
uniquement. Elle doit être connectée seulement à des réseaux ou des circuits
qui ne sont pas routés au réseau ou au bâtiment extérieur.
Reset Button — Using a stylus or small screwdriver, press and release this button
to reset the unit to different tiers of factory defaults, including Dante settings such as
device name, IP address, channel names, and audio format (see Reset Modes below).
button (see figure 4,
RESET
Set the IP configuration to default settings
Clear all audio channel routing
Set the Dante device name and channel names to default
Power LED Indicator
A
USB Config Port
B
) with a stylus or Extron Tweeker to
D
on page 29 for the command to reset output
AXI 02 AT • Installation and Operation
AT (PoE) Port
C
Reset Button
D
Identifying a Physical
Command
6
Advertisement
Table of Contents
