Front Panel Features - Extron electronics AXI 22 AT D User Manual

Front Panel Features

A
B
C
D
Figure 9.
NOTE: Before setting the front panel controls, you must remove the faceplate (
To use a power injector: Connect a straight-through Ethernet cable to the power supply
and a switch or router. This cable carries network information from the switch or router to
the power supply input. A second straight-through cable carries the network information and
48 VDC power from the power supply to the AXI. Connect the IEC power cord to a 100 VAC
to 240 VAC, 50-60 Hz power source.
Figure 8 shows the Extron XTP PI 100. Your power injector may look different.
~
100-240V 50-60Hz
0.4A MAX
XTP XTP PWR
PWR
To network switch To AXI 22 AT D
Figure 8. Connecting a Power Injector to AXI 22
For instructions on installing, connecting, and using the power injector, see the
documentation provided by the manufacturer. For the Extron XTP PI power injectors, user
and installation guides are available at
INPUT
1
A
INPUT
2
Extron
Faceplate Attached
Faceplate
Mic/Line Input 1
Input 1 Gain Control
Input 1 Phantom Power switch
AXI 22 AT D Front Panel
www.extron.com .
B
48V
1
C
10 15 10 15
20 20
5 5
0dB 25dB 0dB 25dB
45 30 45 30
E 40 35 40 35
2
F
48V
Faceplate Removed
Mic/Line Input 2
E
Input 2 Phantom Power switch
F
Input 2 Gain Control
G
Reset button
H
AXI 22 AT D • Installation and Operation
D
G
H
).
A
11