Queue Ef; Queue Wfq - HP A8800 Series Command Reference Manual

[Sysname] traffic behavior af_behav
[Sysname-behavior-af_behav] queue af bandwidth 5000
[Sysname-behavior-af_behav] quit

queue ef

Syntax
queue ef bandwidth bandwidth [ cbs burst ]
undo queue ef
View
Traffic behavior view
Default level
2: System level
Parameters
bandwidth: Guaranteed bandwidth for expedited forwarding (EF), which ranges from 64 to 10000000
in kbps.
cbs burst: Sets the committed burst size (CBS) in bytes, which specifies the maximum burst traffic size
permitted when the average traffic rate conforms to the configured bandwidth. CBS ranges from 1600 to
1000000000 bytes, and defaults to bandwidth×25. The CBS should be greater than traffic transmitted
within 50ms at the rate of bandwidth. Otherwise, the burst traffic rate is too low, and the burst traffic
transmission is affected.
Description
Use queue ef to enable expedited forwarding (EF), and configure the guaranteed bandwidth for the EF
traffic.
The total bandwidth assigned to AF and EF in a policy must be no more than the maximum available
bandwidth of the interface where the policy is applied.
Related commands: queue af.
Examples
# Enable EF and set the guaranteed bandwidth to 30 Mbps for the EF traffic in behavior ef_behav.
<Sysname> system-view
[Sysname] traffic behavior ef_behav
[Sysname-behavior-ef_behav] queue ef bandwidth 30000
[Sysname-behavior-ef_behav] quit

queue wfq

Syntax
queue wfq
undo queue wfq
View
Traffic behavior view
94