HP A8800 Series Command Reference Manual page 72

|: Filters command output by specifying a regular expression. For more information about regular
expressions, see Fundamentals Configuration Guide.
begin: Displays the first line that matches the specified regular expression and all lines that follow.
exclude: Displays all lines that do not match the specified regular expression.
include: Displays all lines that match the specified regular expression.
regular-expression: Specifies a regular expression, a case-sensitive string of 1 to 256 characters.
Description
Use display qos vlan-policy to display information about VLAN QoS policies.
If no direction is specified, this command displays VLAN QoS policy information for both inbound and
outbound directions.
If no slot number is specified, this command displays all VLAN QoS policy information on the device.
Examples
# Display information about the QoS policy test on the card in slot 6.
<Sysname> display qos vlan-policy name test slot 6
Policy user1
Vlan 2: inbound
Table 24 Command output
Field
Policy
Vlan
Inbound
# Display the QoS policy applied to VLAN 2.
<Sysname> display qos vlan-policy vlan 2
Vlan 2
Direction: Inbound
Policy: user1
Classifier: class1
Operator: AND
Rule(s) : If-match acl 2001
Behavior: test
Accounting Enable:
0 (Packets)
0 (Bytes)
Committed Access Rate:
CIR 2000 (kbps), CBS 30000 (byte), EBS 100 (byte), PIR 25000 (kbps)
Red Action: discard
Green : 0(Bytes)
Yellow: 0(Bytes)
Red
Filter Enable: permit
Marking:
Remark dot1p COS 2
Description
Name of the QoS policy.
ID of the VLAN where the VLAN policy is applied.
The QoS policy is applied in the inbound direction of the VLAN.
: 0(Bytes)
66