Qos Gts Queue - HP A8800 Series Command Reference Manual

Settings in interface view take effect on the current interface. Settings in port group view take effect on all
ports in the port group. Settings in subinterface view take effect on the current subinterface.
The qos gts any command and the qos lr outbound command are mutually exclusive for an interface,
subinterface, or port group.
In respect to subinterfaces, only the Layer 3 Ethernet subinterfaces on the SPE cards support the qos gts
any command.
The qos gts any command does not take effect on MFR interfaces, FR POS interfaces, and FR serial ports.
Examples
# Configure GTS for all traffic of interface GigabitEthernet 2/1/1, setting CIR to 640 kbps and CBS to
1024000 bytes.
<Sysname> system-view
[Sysname] interface GigabitEthernet 2/1/1
[Sysname-GigabitEthernet2/1/1] qos gts any cir 640 cbs 1024000

qos gts queue

Syntax
qos gts queue queue cir committed-information-rate [ cbs committed-burst-size ]
undo qos gts queue queue
View
Interface view, port group view
Default level
2: System level
Parameters
queue queue-number: Shapes the packets in the queue identified by the queue-number argument. The
queue-number argument can be a number or keyword, and the number-keyword mapping is shown
in Table 30.
Table 30 Description on the queue argument
Keyword
af1
af2
af3
af4
be
cs6
cs7
ef
cir committed-information-rate: Specifies the committed information rate (CIR) in kbps. The value range
for committed-information-rate varies by interface type as follows:
Queue number (decimal)
1
2
3
4
0
6
7
5
82