Cbq Configuration Commands; Queue Af - HP A8800 Series Command Reference Manual

Use undo qos wfq weight to restore the default scheduling weight for a WFQ queue on a port.
By default, the scheduling weight of a WFQ queue is 1.
Settings in interface view take effect on the current interface. Settings in port group view take effect on all
ports in the port group. Settings in subinterface view take effect on the current subinterface.
In respect to subinterfaces, only the Layer 3 Ethernet subinterfaces of the SPE cards support this
command.
An SPC card does not support this command.
Related commands: display qos wfq interface.
Examples
# Set the scheduling weight of queue 3 and queue 4 to 20 and 30 on GigabitEthernet 2/1/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet2/1/1
[Sysname-GigabitEthernet2/1/1] qos wfq 3 weight 20
[Sysname-GigabitEthernet2/1/1] qos wfq 4 weight 30

CBQ configuration commands

CBQ configuration commands are applicable to only SPE cards.

queue af

Syntax
queue af bandwidth bandwidth
undo queue af
View
Traffic behavior view
Default level
2: System level
Parameters
bandwidth: Guaranteed bandwidth for assured forwarding (AF), which ranges from 64 to 10000000 in
kbps.
Description
Use queue af to enable assured-forwarding (AF) and set the guaranteed bandwidth for the AF traffic.
Use undo queue af to remove the configuration from the traffic behavior.
The total bandwidth assigned to AF and EF in a policy must be no more than the maximum available
bandwidth of the interface where the policy is applied.
Related commands: queue ef.
Examples
# Enable AF and set the guaranteed bandwidth to 5 Mbps for the AF traffic in behavior af_behav.
<Sysname> system-view
93