10
LOADING AND INSTALLATION
10.2.2 Instructions for mounting the base unit
When mounting the programmable controller to an enclosure or similar, fully consider its
operability, maintainability and environmental resistance.
(1) Module mounting position
5mm or more
10
- 12
10.2 Module Installation
10.2.2 Instructions for mounting the base unit
Keep the clearances shown in Figure 10.13 between the top/bottom faces of the
module and other structures or parts to ensure good ventilation and facilitate module
replacement.
(a) In case of base unit
Indicates the panel top, wiring duct or any
part position.
5mm or more
* 1: For wiring duct with 50mm or less height. For other cases, 40mm or more.
Figure 10.13 Module mounting position
30mm
*1
or more
Panel
30mm
or more
Programmable
logic controller
Door
20mm
or more