Mounting And Installation Of The Q Series Large Type Base Unit (Ans Series Size) - Mitsubishi Electric ANS-Q-LARGE-U User Manual

5.3 Mounting and Installation of the Q Series Large Type
Base Unit (AnS Series Size)
The following explains how to mount or install the Q series large type
base unit (AnS series size).
(1) Installing a base unit on a panel
To install a base unit on a panel such as a control panel, tighten the
base unit mounting screws.
(2) Mounting a base unit on a DIN rail
The following shows a procedure to mount the base unit on a DIN
rail.
(a) Installing DIN rail mounting adapter
Base unit rear
Insert the adapter (large) into the
grooves of the base unit from below.
(b) Mounting on a DIN rail
The following figures show how to install the DIN rail mounting
adapters on the base unit rear.
Place the hook of the adapter
(small) in the lower hole.
Remove the base cover and mount the base unit on a DIN rail.
Put the base cover on after the completion of the next step, (c).
When extension bases are used, determine the number of
extension stages in this step.
Base cover
DIN rail
Push the bottom of the adapter (large)
far enough until it "clicks".
21
Push the top of the adapter
(small) far enough until it
"clicks".