Mitsubishi Electric QS001CPU User Manual page 81

10
LOADING AND INSTALLATION
Note the following points when mounting a DIN rail.
Mounting a DIN rail needs special adapters (optional), which are to be prepared by the
user.
DIN rail adapter
Adapter(Large)
Q6DIN2
Base unit rear
Insert the adapter (large) into the grooves of
the base unit from below.
4) Fit the mounting screws into the holes at the bottom of the base unit, and then
retighten the 4 mounting screws.
Note1 : Install the base unit to a panel, with no module loaded in the right-end
slot.
Remove the base unit after unloading the module from the right-end
slot.
(a) Applicable adapter types
For QS034B
Table10.2 Parts included with DIN rail adapters
Adapter(small)
2 3
(b) Adapter installation method
The following figure shows how to attach DIN rail adapters to the base unit.
Figure 10.5 Adapter installation method
Quantity of included parts
Mounting screw
Square washer
(M5 10)
2
Place the hook of the adapter
(small) in the lower hole.
Push the bottom of the adapter (large) far enough
until it "clicks".
10.2 Module Installation
10.2.1 Installation precautions
: Q6DIN2
Stopper
2 2
Push the top of the adapter
(small) far enough until it
"clicks".
10
- 7
9
10
11
12