Ericsson iPECS-100 Feature Description And Operation Manual page 427

iPECS-LIK
Feature Description & Operation Manual
5. Call Blocking ... and so on
Other Configurations
1. Answer Mode
2. Key, Tone
3. Digit Map (if SIP Phone support dial by Digit Map solution) :
If you can utilize SIP Phone's programmable Dial Digit Map, you can make
immediate sending out dials w/o press [SEND] or "#" key.
<Refer to below>
- Digit Map (for Call Setup in SIP Phone)
: you can program Digit Map according to System Numbering Plan
Example) in case of "LIP8002/88xx" SIP Phone type
x.T|0|xx#|xxx#|1xxx|2xxx|3xxx|xxxx+#
Explanation)
"9" : dial "9" for attendant call, you can specify other single digit if you want it to be
sent immediately when press the digit without ending by "#"
'1xxx', '2xxx', '3xxx' : extension numbering, you can specify other 2 or 3 or 4 or
more digits starting with a specific prefix digit or digits
'xx#', 'xxx#', 'xxxx#' : dial the other 2, 3 or 4 digits and press "#" to send 'xxxx +
#' : dial the other more than 4 digits and press "#" to send
- Digit Map (for 2nd Dial Tone) : Play self dial tone by SIP Phone
Example) in case of "LIP8002/88xx" SIP Phone type
0 : // "0" is CO access code in the first CO group
System(MFIM) Programming
st
1 Registration
1. A SIP Phone will be registered as an Extension of LIK system.
2. Check Extension Number : System ID & Numbering Plans / Flexible Station Number
(105). You can use an Extension Number that is not assigned by other Extension or
an empty Number. As example below, you can use "1050" because it is not yet
assigned by other Extension or "1051" because it is unused and empty number.
3. Input Station User Login Table(443)
–
ID (Mandatory) : An unique string or Extension Number. This should be same as
SIP Phone's "Authorization ID" value.
–
Password (Optional) : A string. If you want to make authentication be
implemented when user register to system, password should be available (not
empty). This should be same as SIP Phone's "Authorization Password" value.
–
Desired Number (Mandatory) : Extension Number. This should be same as SIP
Phone's User Name (or Phone Number) value.
386
Issue 6.1