Ericsson iPECS-100 Feature Description And Operation Manual page 308

iPECS-LIK
Feature Description & Operation Manual
SLT
To make a page,
1. Lift the handset.
2. Dial the desired paging code.
3. If assigned, after the Page Warning Tone, make announcement.
4. Replace the handset, go on-hook.
To queue for a page when busy tone is received.
1. Dial "556", the Call Back code.
2. Replace the handset returning to idle.
Conditions
1. Stations, which are denied access to paging, will receive error tone when any Page
Access code is dialed.
2. Stations dialing a Page Code will be queued when any of the other Internal or
External Page zones are busy.
3. DTMF signals from stations are transmitted through the systems External Page port
after access.
4. If an iPECS Phone user attempts to page using the speakerphone, pre-selection will
be activated and the display shows "LIFT THE HANDSET TO PAGE".
5. Stations in DND or busy will not receive Page announcements.
6. Stations, which are not included in any Internal Page Zone, will not receive any
page, including All Call.
7. For external paging, an external amplifier and speaker(s) are required.
8. The systems External Control Contacts may be assigned to activate when External
Page is accessed.
9. A station is permitted only one Page Zone queue request at a time. If a station
attempts another Page Zone queue, only the later queue request is honored.
10. When a busy Page Zone becomes idle, the system will select the oldest page
queue, and signal the appropriate station. The signaled station will have an audible
ring indicating the queue callback. The audible ringing will be a distinctive signal.
The All Page Zone, while signaling a queued station, is considered busy. In
addition, the All Page Zone is considered busy when any page zone is active.
11. The queue recall is always in the tone ring mode regardless of the station's ICM
signaling mode.
12. If the waiting station is idle, the Call Back ring signals the station for 15 seconds,
after which, the queue is canceled and the next station in the queue is signaled.
13. If the waiting station is busy, and the Page zone becomes available the next idle
station in the Page Queue list is signaled and the busy waiting station is placed at
the bottom of Page Queue list. If there is no idle next station in the Page Queue,
the Page Queue is canceled.
14. When the waiting station goes to idle, and both a "Page Queue" and "CO Call back
Queue" exist, the Page Queue is given priority.
271
Issue 6.1