Honeywell MX7 Tecton User Manual page 136

Message Explanation and/or corrective action
Switching to admin- See the explanation of the "Registry read failure" above. AppLock is switching
registry read failure into Admin mode. If a password has been configured, the prompt will be dis-
played and will not be dismissed until a valid password is entered.
Switching to Taskbar- In administration mode, the taskbar is visible and enabled.
ScreenMode
Switching to user The registry was successfully read and AppLock is starting the process to
mode switch to user mode.
Switching to user-hot- The system is currently in admin mode and is now switching to user mode. The
key press switch occurred because of a hotkey press by the administrator.
Taskbar hook failure AppLock is unable to control the taskbar to prevent the locked application from
re-enabling it.
Taskbar hook OK AppLock successfully installed control of the taskbar.
Timeout looking for After the application is launched, AppLock must wait until the application has
app window initialized itself before proceeding. The application did not start successfully
and AppLock has timed out.
ToUser after admin, The user mode switch is attempted when the device boots and after the admin-
not at boot istrator presses the hotkey. The mode switch is being attempted after a hotkey
press.
ToUser after admin- The switch to user mode is being made via a hotkey press and the administra-
app still open tor has left the application open and has not made any changes in the configu-
ration.
ToUser after admin-no If user mode is being entered via a hotkey press, the administrator may have
app or cmd line left the configured application open. If so, AppLock does not launch the appli-
change cation again unless a new application or command line has been specified; oth-
erwise, it just locks it.
Unable to move desk- The desktop is moved when switching into user mode. This prevents them from
top being visible if the application is exited and restarted by the timer. This error
does not affect the screen mode switch; processing continues.
Unable to move task- The taskbar is moved when switching into user mode. This prevents them from
bar being visible if the application is exited and restarted by the timer. This error
does not affect the screen mode switch; processing continues.
Unhook taskbar wnd- AppLock could not remove its control of the taskbar. This error does not affect
proc failure AppLock processing
Unhook wndproc fail- AppLock could not remove the hook that allows monitoring of the application.
ure
Unhooking taskbar In administration mode, the taskbar should return to normal operation, so Ap-
pLock's control of the taskbar should be removed.
Unhooking wndproc When the administrator leaves user mode, the device is fully operational; there-
fore, AppLock must stop monitoring the locked application.
WM_SIZE adjusted This message denotes that AppLock has readjusted the window size.
X after Ctrl+L Processing the backdoor entry.
Ret from password Return value from password dialog.
<#>
Decrypt data len <#> Length of decrypted password.
Window handle to The window handle that is passed to the enumeration function. This message
enumwindows=%x can be used by engineering with other development tools to trouble shoot ap-
plication lock failures.
WM_WINDOW- Output the window size after it has been adjusted by AppLock
POSCHG adjust-
ed=%x
130
Level
LOG_PROCESSING
LOG_EX
LOG_PROCESSING
LOG_PROCESSING
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX
LOG_EX