Using The Keypad; Using A Control Panel - Honeywell MX7 Tecton User Manual

Speaker volume can be adjusted to a comfortable level for the listener by using key presses or by changing settings in a control
panel. Speaker sounds can be disabled.

Using the Keypad

Note: Speaker sounds must be enabled before the following key sequences can adjust the volume.
The volume is increased or decreased one step each time the volume key sequence is pressed.
To adjust speaker volume:
• Tap the Orange key then the Scan key to enter volume change mode.
• Use the Up Arrow and Down Arrow keys. A beep is emitted at each arrow key press. When the volume reaches maximum
level, two extra beeps are emitted.
• Press any key, except the keys you used to adjust the volume, to exit.
Volume control using a keypad key press has six volume settings that match those supported by the control panel. Volume
does not "roll-over" from minimum to maximum or from maximum to minimum. Continuously holding down the up or down
arrow keys does not cause an automatic repeat of the up (or down) arrow key.

Using a Control Panel

Tap Start > Settings > Control Panel >
OK to save the change. You can also select / deselect sounds for key clicks and screen taps and whether each is loud or
soft. As the volume scrollbar is moved between Loud and Soft, the speaker emits a tone each time the volume increases or
decreases.
16
(page 100) > Volume tab. Change the volume setting and tap
Volume and Sounds