Honeywell MX7 Tecton User Manual page 85

KeyMap
Assign settings by clicking radio buttons and selecting keys from the drop down boxes. Tap the OK button when fin-
ished. The changes take effect immediately.
Remap Key to a Single Key
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select the value from the remapped key from the Remapped Key pulldown list.
4. Click OK to save the result and close the Keypad Control.
Remap Key to a Unicode Value
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select Unicode from the Remapped Key pulldown list.
4. There are two Unicode text boxes located on the lower part of this tab. Enter the Unicode value in the left text-
box and the Unicode character is displayed in the right textbox.
5. Click OK to save the result and close the control panel.
Remap Key to a Key Sequence
1. Select the modifier key from the Modifier Mode options.
2. Select the key to be remapped from the Key pulldown list.
3. Select Key Sequence from the Remapped Key pulldown list.
4. Select the first key for the multiple key sequence from the pulldown list.
5. Press the Add button to add the key to the multiple key sequence shown in the Key Sequence box. Repeat
this step until all keys desired have been added to the key sequence. If necessary, use the Clear button to
erase all entries in the Key Sequence box.
6. Click OK to save the result and close the Keypad Control.
Note: A key can only be used once in a multiple key sequence. For example, an F1 key added to a key sequence
means an F1 key cannot be used again in the same key sequence.
73