Table of Contents
Advertisement
4. This should bring up the Gateway Administration page in a separate browser window.
5. Check on the Static IP address radio button.
6. Specify at a minimum the static IP address and netmask fields. Ask your system
administrator if you are unsure about the settings specific to your network.
Set IP
7. Click on
8. Restart the ēKo gateway by pressing the
Administration page, it will boot with the new static address.
WARNING
Make sure that the IP settings are correct as it is difficult to recover from a mistake. If you loose
the ability to connect to your gateway after setting an incorrect fixed IP, you can use the method
in section 7.3 to recover.
Doc. # 7430-0710-01 Rev. C
button.
Restart
button at the bottom of the
78
Page
Advertisement
Table of Contents
