ēKo Pro Series User's Manual
6.4.2 Configure Alerts Page
The ēKoView alert manager allows users to define alert conditions based on any sensor value
from any sensor node. An alert is a user programmable event that gets triggered when sensor
data goes outside pre-defined threshold. The Configure Alerts page can be accessed from
Configure Alerts
link in the Configure tab.
Add a new alert:
To add a new alert, click on the "
" button at the bottom of the page. This will open up Add
Add
Alert dialog window as shown below.
53
Page
Doc. # 7430-0710-01 Rev. C