Table of Contents
Advertisement
ēKo Pro Series User's Manual
Figure 3-4. ēKo gateway LED indicators
Status LEDs
Power button
will automatically power-up. Check the 'power-on' button on the lower front. It should
now be illuminated. It takes about 2 minutes for the gateway to become fully operational.
2. After the ēKo gateway has powered up, you should see the front indicators showing the
following status.
Indicator
Power Button
Ready/Status
Ethernet
Disk2
Disk1
At the end of the boot-up period, ēKo gateway will emit an audible beeping sequence,
3.
which can be decoded to find the IP address (Refer to section 7.1).
Wait for the "Disk 1" LED to turn green; this will take 1 to 2 minutes.
4.
IMPORTANT:
to correctly shutdown the operating system and takes about 40 seconds. Do not shut down the
gateway by just unplugging it, this can cause corruption of its files.
3.4 Starting up ēKoView
The primary interface to the ēKo gateway can be accessed using a Web browser on a locally
connected PC.
3.4.1 System Requirements
PC connected to the Internet.
Web browser, e.g. Microsoft's Internet Explorer or Mozilla's Firefox
Adobe's Flash Player 9.x. To install Flash Player 9.x visit Adobe's web site:
http://www.macromedia.com/software/flash/about/
13
Page
Table 3-1. ēKo Gateway LED status description
Color
Green
Green/flashing Yellow
Yellow then flashing Green
Flashing Green
Solid Green
Green
To turn off the power, press the power button. This allows ēKo gateway
Status
System on
System running
System boot
Network activity
XServe Running
USB disk running
Doc. # 7430-0710-01 Rev. C
Advertisement
Table of Contents
