ēKo Pro Series User's Manual
When done, click on
minutes to complete calculations and you will receive the message below. Click on "
if you want to proceed.
The newly created calculation should now appear in the "Manage Calculations" list. These
calculations will now show up as a sensor measurement with each of the associated nodes. They
can also be displayed or plotted as any sensor measurements.
Edit an existing calculation:
To edit an existing calculation, highlight the calculation you wish to edit and click on the "
button at the bottom of the page and the "Edit Calculation" dialog window will appear. You can
edit the parameters that you want to change. When done, click on the "
65
Page
OK
button. If the Start date chosen is in the past you, it could several
Edit
" button.
OK
Doc. # 7430-0710-01 Rev. C
"
Yes
"