Table of Contents
Advertisement
6.
Axis-2 chart
: This is the similar to Axis-1 but plots data on a secondary axis.
NOTE:
When using dual axis graphs, plot the first axis using line mode and the second using
point mode.
7.
OK
Click on
and chart it.
6.3.2 Viewing chart data
To view a specific value and time on the chart, place the mouse over the point and a pop up with
the exact value and time will appear. The slider bar at the bottom of the chart page allows users
to shift re-scale the time range on x-axis. To shift the time range, left-click the mouse on either
ends of the slider bar and slide the mouse.
Each chart is displayed as a named tab in the Charting window. Users can switch between charts
by clicking on the named tab for the chart to be displayed. Unused charts can be closed by
clicking on the in the chart tab.
When viewing a detailed data set, users can choose to select the
continually update the chart with any new data that arrives from the network. This button is only
available on detailed data, and is not available when viewing aggregate data sets.
When viewing a chart, users can click the Refresh button on the top right of the window to
refresh the chart with current data. When viewing a chart with a pre-defined Date Range, this
will readjust the chart window with data from the end date of the date range starting from the
current time.
Doc. # 7430-0710-01 Rev. C
button. After completing the wizard ēKoView will retrieve the specified data
Live Data
check-box. This will
46
Page
Advertisement
Table of Contents
