Table of Contents
Advertisement
ēKo Pro Series User's Manual
Save position
5.4.3 Configuring the nodes and sensors
When data from a new ēKo node first appears at the gateway, the ēKoView will give the node
and its attached sensors pre-assigned names. The node will be labeled as 'Node xxx' where xxx
is its network address (same as ID of the node). An eS1101 ēKo sensor name will be defaulted to
"eS1101 Soil Moisture: Port x" where x is the port number of the ēKo node that the sensor is
attached to. ēKoView allows users to rename both the node and sensor. You can access this page
by clicking on "
" button in the Configure tab. The commissioned nodes will
Configure Nodes
appear in the "Configure existing nodes" list.
32
Page
Doc. # 7430-0710-01 Rev. C
Advertisement
Table of Contents
