Deploying Ë Ko Sensors - Aceinna eko Pro Series User Manual

ēKo Pro Series User's Manual
IMPORTANT:
for a few hours before burying soil sensors in case the node needs to be moved or another node
used as a relay. (See section 6.5.1). If the yield is less than 85%, refer to the section 6.5.2 before
proceeding to the next section on attaching the sensors.
5.3 Deploying ēKo Sensors
Presently ēKo Pro series system supports five external sensors and one internal set of sensors:

eS1101 external soil moisture and soil temperature sensor. Both sensors are attached to a
single ēKo node connector

eS1101 soil water content sensor

eS1201 external ambient temperature and humidity

eS1301 leaf wetness sensor

eS1401 solar radiation sensor

Internal sensors in the node which measure:
o Battery voltage
o Solar voltage
o Enclosure temperature
29
Page
Figure 5-7. Example deployment in orchards
Normally after deploying the network, users should monitor the network
Doc. # 7430-0710-01 Rev. C